Home » What I Found When I Crawled Under Rivian’s Amazon Delivery Van

What I Found When I Crawled Under Rivian’s Amazon Delivery Van

Pasted
ADVERTISEMENT

Today I stopped by Munro & Associates to talk about vehicle cost reduction (sounds boring, but you just wait). And on my way home I saw the new Amazon “EDV” delivery trucks “powered by Rivian.” So I stopped and took a close look. Here’s what I saw.

Really, I stopped because I knew my coworker Jason would have a lot to say about the vehicle’s lighting situation. The rear taillight, in particular, is truly special, as Jason makes clear in his analysis below. As for what I have to say about this machine? Well, naturally I slid underneath to look at the hardware.

Vidframe Min Top
Vidframe Min Bottom

A Brief Look Underneath The Amazon EDV ‘Powered By Rivian’

Before I get into the hardware, let’s first identify what we’re looking at. Amazon’s delivery vans come as three models, named after their storage capacity in cubic feet (rounded up to the nearest 100 apparently): EDV 500, EDV 700, EDV 900. If you look closely as the image below, you’ll see that the length between the models changes by one rectangular “section.” Behind the rear doors, the EDV 500 has three sections, the EDV 900 has five, and the van above — the EDV 700 — has four. I’m not sure that the EDV 500 or EDV 900 are even out yet, so it’s no surprise that the one I saw had those four rear “sections.”

ADVERTISEMENT

Now that we know what we’re looking at, let’s check out what’s going on underneath.

Just under the rear bumper, looking forward, you’ll see a steel skateboard/frame with a steel body mounted up top. The rear suspension is a coil-sprung torsion beam design located laterally by a track bar (a cheap but robust design, you’ll find something like this under the back end of an entry-level front-wheel drive car like a Hyundai Accent). I did notice that the track bar mount on the frame looks to have another stamped steel piece bolted to it — I’m wondering if this acts as a reinforcement for the bracket welded to the frame? (I.e. to make sure the track bar bracket welds don’t fail under high loads?).

Quick note: I don’t know what that rectangular prism on the left side of the photo above is. It looks almost like a stack-style heat exchanger, but obviously it’s something electrical based on the wires going to it. Hmm. Update: I’m told it’s a noisemaker so people can hear the vehicle when it’s moving.

ADVERTISEMENT

Looking back at the rear suspension from ahead of the rear axle you can see one of the enormous trailing arms mounted to the frame, and you can see a seriously gigantic aero shield that diverts air under the rear suspension:

Also visible in the image above is a small tire spat (as Chrysler’s aero team called them) just ahead of the rear wheel to reduce drag. There are some spats up front, too, as well as a big plastic aero shield:

ADVERTISEMENT

That front aero shield is long. It starts just under the front fascia and continues under the front subframe, under the drive unit, and then just keeps on going:

And going:

Eventually it comes to an end, exposing the battery pack shield. You’ll see how there’s only a small bit of the underbelly exposed, as that huge rear aero shield meant to divert air under the twist beam reaches quite far forward:

ADVERTISEMENT

Let’s move back towards the front of the car and peek at the suspension: It’s a double-wishbone design. And, as a reader pointed out in the comments below, you’ll notice that there’s no coilover or coil spring or traditional leaf spring or torsion bar. Instead, you’ll see a white thing attached to the top of the lower control arm — that’s a composite transverse leaf spring. That’s pretty bizarre if you’re used to passenger cars (as for cargo vans, I’m told the Iveco Daily cargo van uses a similar spring arrangement). You might recall seeing such a layout in a Chevy Corvette or an SPA-platform Volvo, with the former more similar to this EDV since it also uses a transverse leaf as part of the front suspension. Another vehicle with a transverse front leaf spring? The Ford Model T!.

ADVERTISEMENT

You’re naturally going to be curious if any of the parts are common with those of the R1T, and — looking at the two together (that’s the R1T’s front suspension below) — I’d say maybe the tie rod ends, but that’s about it. The basic front suspension design is similar, sure, but as for parts sharing, I don’t see anything obvious:

Now let’s look at the really good stuff — the drive unit.

This is a front-wheel drive truck, so the drive unit sits just aft of the front axle, with the gearbox output ahead of the motor. Notice how the unit hangs off the frame via what looks like a cast aluminum bracket that bolts onto a mount on the frame. I find this interesting, because presumably this drive unit is fastened to the front subframe, which is fastened to the main vehicle chassis/frame. So why fasten the motor directly to the frame?

ADVERTISEMENT

I’m assuming the drive unit-to-subframe mounting scheme doesn’t constrain the motor sufficiently, so under load, the motor would want to torque — this frame mount is there to prevent that. And I’m guessing it was just easier, perhaps from a packaging standpoint, than constraining the motor via the subframe?

Maybe it’s not that weird. Maybe a drive unit-direct-to-body mounting isn’t that uncommon among EVs? Munro would know.

Anyway, you can see that all the power electronics sit aft of the front drive unit, just ahead of the battery pack, and hidden by that huge front aero shield.

Lighting Design: This Section Written By Jason Torchinsky

ADVERTISEMENT

Overall, I’m really impressed that Rivian seems to have taken the time and effort to develop bespoke lighting elements for this delivery vehicle, especially since this particular segment is among the most likely to just use cheap, off-the-shelf lighting. I guess when you have Amazon money behind you, you can have some fun, and it looks like Rivian did.

The round headlight/indicator units at the front are key in establishing the EDV 700’s (Rivian’s phoned-in name for the van) simple, friendly face. They also seem to have snuck in a little Amazon arrow-smile thing in the center there.

They’re appealing round units, with an inner clear projector lens and an outer pair of half rings that functions both as a DRL and turns amber for indicator use.

ADVERTISEMENT

They’re not exactly revolutionary, but the decision for simple round light graphics and that flat glossy black panel is a welcome change from the normal default of an overdone grille and squinty-blob light units that give vehicles a perpetually pissed look.

The EDV 700 looks friendly and eager, like a whale who’s here to help.

Around back, though, we get into something really special. I’ll let David’s earnest shock set the mood here:

I think David is exactly right; this is very likely the longest taillight ever developed by human hands. Even recent Escalades and Volvo V70s, with their massive full D-pillar taillight towers can’t match what’s going on here. The back of the Rivian van looks a bit like it’s designed to dock with a special port, like a spacecraft, with a protruding lip that you can imagine acting as a sort of hermetic seal.

ADVERTISEMENT

Around that seal, starting about 1/4 from the bottom of the van and going up, over, and down like a horseshoe, is the taillight strip, a ring road of red light. It all appears to be able to illuminate, and at top the strip blisters to form three red clearance lamps.

The bottom ends form L shapes on both sides and there’s a dark glossy area that house the rear turn indicators, which, based on video I’ve seen, appear to be red instead of amber, which is disappointing.

Brake lamps may be here as well, or the big red inverted “U” may light up, or both; I haven’t see that yet.

ADVERTISEMENT

Reverse lamps and reflectors are housed in a pair of frankfurter-shaped units below the rear door. Seems like there would have been plenty of room for these in the main lights, but maybe the reverse lamps give better lighting below? They could also serve to illuminate that step, perhaps?

The Interior

Based on what we’ve heard about Amazon drivers, I think the most surprising omission from the interior is no obvious urinal or urine receptacle of any sort, which–and I’m not kidding here–seems like would be a pretty good idea. If you know your drivers are peeing in bottles, why not offer a better solution?

Urine aside, the interior looks pretty good; lots of hard-wearing-looking vinyls and rubbers and plastics. The blue accents (and kicky blue seatbelt) give some nice color interest to the otherwise grayscale interior, and that seat looks well-padded and comfortable.

The legroom is a little unusual, with a sort of step that runs the length of the cab under the dash, but it doesn’t appear anyone would actually be cramped. The passenger’s side appears to have a folded jump seat, though it’s likely only for very occasional use, like if Jeff Bezos wanted to ride shotgun or something. The instrument cluster appears to be an all LCD screen setup, and the center-stack screen is a landscape-oriented widescreen LCD panel.

ADVERTISEMENT

All in all, the Amazon EDV is just a lovable and fun machine with the biggest taillight in vehicular history. And if you don’t think that’s great, seek help.

Share on facebook
Facebook
Share on whatsapp
WhatsApp
Share on twitter
Twitter
Share on linkedin
LinkedIn
Share on reddit
Reddit
Subscribe
Notify of
85 Comments
Inline Feedbacks
View all comments
Bret Fowler
Bret Fowler
1 year ago

Hopefully this is the start of reintroducing happy round headlights. I’m pretty sick of the “squinty angry face” being the default for EVERY car.

Tom Tokugawa
Tom Tokugawa
1 year ago

The front has a very strong resemblance to the Honda E.

Not that that’s a bad thing.

ADDvanced
ADDvanced
1 year ago

Bravo. I love this article and the fact you went under and captured all this. Really interesting, and it’s why this website will succeed.

MikeInTheWoods
MikeInTheWoods
1 year ago

I love that styling. Friendly, not angry or intimidating like 98% of modern vehicles. Rivian nailed it with the future look. It would be amazing if the “dock seal” Jason mentioned fit into an actual docking gasket at the warehouse and the surround light went green when the vehicle was properly docked. With modern tech it is possible. Also, I love the integrated and yet stylish grab handles out back too. Why is the USPS sucking so bad at choosing a new vehicle? Oh, I forgot about politics and Postmaster insider trading. That explains it.

Jason H
Jason H
1 year ago

“I did notice that the track bar mount on the frame looks to have another stamped steel piece bolted to it”

David! For those of us who aren’t as familiar with car parts as you, open up Preview on your Mac and add some red arrows so we know what you are talking about!

T18
T18
1 year ago

Not sure I’m used to seeing a David Tracy article where he crawled under something and didn’t find lots of rust.

Anoos
Anoos
1 year ago

It is possible that the rear fairing is also designed to seal the back of these to Amazon-specific loading docks to prevent opening the loading dock doors to the elements?

ZeGerman
ZeGerman
1 year ago

Looks like a rather handsome delivery vehicle. I suppose the front end on this thing is as close as we’re going to get to having a Honda e in the U.S. 🙁

Slow Joe Crow
Slow Joe Crow
1 year ago

I was initially surprised that the body was steel since aluminum and fiberglass ate more common. UPS uses aluminum bodies and fiberglass hoods on their custom package cars. On the other hand steel is cheaper, easier to form and repair and weight is less of an issue in package delivery since you’re more likely to cube out.

It will interesting to see this in service and get some data on range and costs

Phlodo
Phlodo
1 year ago

Hey Autopian, do you think we might see an article on how Amazon and similar fleets set up charging infrastructure? I think it could hold interesting insights on how the country as a whole might do it.

I assume they’ll need to charge many vehicles overnight, all at once or in shifts with someone to change over the plugs halfway through the night. Either way that’s a lot of level 2 chargers.

I would love to see fleet operators like Amazon, or especially the post office (if they get it together for evs) offer some public plugs for use in the daytime when the working vehicles are out. It wouldn’t make a mainstay of public charging infrastructure, but could be a useful backup for when the fast charger you were counting on is broken and you need some miles to get to the next one. Post offices are well spaced geographically and typically have at least a couple of parking spots to spare. It could be an extra revenue source for the old USPS too.

Dusty Hornblower
Dusty Hornblower
1 year ago

Can’t wait for the AWD camper version.

Scalewoodman
Scalewoodman
1 year ago

Good thing they didn’t leave the keys in it! He’d have taken it for a joyride too…

Fuhrman16
Fuhrman16
1 year ago

So does Amazon have some company law in place or something that disallows their drivers from using a restroom while on the job that they need to pee in the van?

Dead Elvis Inc.
Dead Elvis Inc.
1 year ago
Reply to  Fuhrman16

No, just wildly unreasonable expectations for their employees. They’d get dinged for “wasting” that time on an essential bodily function.

Balloondoggle
Balloondoggle
1 year ago

What I really like about this article, and the site in general so far, is that I’ve learned something here. I had never heard of a transverse leaf spring so I did a quick search and figured it out.

I often learn something new from a DT writeup, so please keep up the good work.

85
0
Would love your thoughts, please comment.x
()
x